To configure the camera with a static IP address:
1. Work with your IT department to determine the correct IP address, subnet mask, and gateway to
assign.
If you are connecting a camera with a Quick-Connect USB device, get the same information for both.
The camera and the Quick-Connect device must have different IP addresses.
2. On the Networking page, set IP Address to Static.
3. Enter the IP address, subnet mask, and gateway as directed by the IT staffer; then save your work.
The camera is now ready to be connected to the network.
Configuring the Quick-Connect USB Device with a Static IP Address
N
ETWORKING PAGE
, Q
UICK
-C
ONNECT
USB
WEB INTERFACE
Caution
Consult your IT department before editing network settings. Errors in network configuration can make the
device inaccessible from the network. Do not change DHCP/Static addressing, IP address, subnet mask,
or gateway unless you are very familiar with the characteristics and configuration of the network where you
install the camera.
Like the camera, the Quick-Connect USB defaults to DHCP. If no DHCP server is available, the Quick-
Connect USB uses the same default static IP address as the camera: 169.254.1.1.
51
Complete Manual for RoboSHOT CAT-5 Professional PTZ Camera Systems
