Set Up Custom Color and Lighting Settings
1. Click any of the CCU scene buttons to load one of the CCU scenes into the camera, then fine-tune it as
needed using the Color Settings controls.
2. Auto Iris – check this box to allow the camera to automatically compensate for the light level, or leave it
unchecked and use the Iris and Gain sliders to make the desired adjustments.
3. Auto White Balance – check this box to allow the camera to adjust the white balance automatically, or
leave it unchecked and use the Red Gain and Blue Gain sliders to make the desired color adjustments.
4. Back Light Compensation (only available in Auto White Balance mode) – check this box if the scene
will have bright lighting behind the main subject of the shot.
5. Detail – adjust the slider as required for amount of detail (Aperture) desired.
Note:
If the video looks grainy or “noisy,” try a lower Detail setting. As in conversation, too much detail is bad.
6. Chroma – adjust the slider as needed for the right level of color intensity.
7. Gamma – adjust the slider as needed for the desired range between bright areas and shadows.
8. When the scene looks the way you want it to, click Store CCU Scene.
9. In the Store CCU Scene dialog box, select which custom scene to store (Custom A, B, or C) and
optionally give it a descriptive name. You can rename it later if necessary.
10. Name and save your custom scene.
Note:
If you make a change that you don't like, you can start over by selecting Auto White Balance, and then
deselecting it again.
Rename a Custom CCU Scene
In the Custom CCU Scene Labels section, edit the text for the desired CCU scene label.
Set Pan, Tilt, and Zoom Speeds
In the Global Preset Non-Tri-Sync Speeds section, set the speeds for movements to presets that do not
use Tri-Synchronous Motion.
24
Integrator's Complete Guide to the RoboSHOT 20 UHD High Performance, Ultra High Definition PTZ Camera