Back of the Camera – RoboSHOT 12 HDBT and RoboSHOT 30 HDBT
Rear panel connections are identical for the older RoboSHOT 12 HDBT and RoboSHOT 30 HDBT
cameras.
From left to right:
n
12 VDC, 3.0 A:
EIAJ-04 jack for local power. Connect only the power supply shipped with the camera
or approved replacement 12 VDC, 3A power supply. This connection is not needed if you use a
OneLINK device or a PoE+ power injector.
n
OneLINK HDBaseT:
RJ-45 connector. Connect to the network (optionally via PoE+ injector) or to a
OneLINK device for streaming and for control via the web interface or Telnet session.
n
HDMI:
HDMI video output connector.
n
HD Video Resolution Select:
Rotary switch to select the video output resolution. See
n
Camera Settings:
DIP switches to set camera behaviors such as IR remote frequency, baud rate and
image flip. See
Camera Behavior Settings – RoboSHOT 12 HDBT and RoboSHOT 30 HDBT
for more
information.
Note
A label on the bottom of the camera lists the rotary and DIP switch settings.
10
Installation Guide for RoboSHOT HDBT High-Performance PTZ Cameras
