camera standby
Set or change camera standby status.
RoboSHOT AVBMP only: Specify
camera1
,
camera2
, or
camera3
.
Synopsis
camera standby { get | off | on | toggle}
Options
get
Returns the camera's current standby state.
off
Brings the camera out of standby (low power)
mode.
on
Stops video and puts the camera in standby
mode.
toggle
Changes the camera's standby state - if it was
not in standby mode, it enters standby; if it was
in standby mode, it "wakes up."
Examples
>
camera standby off
OK
>
Brings the camera out of standby mode.
>
camera standby get
standby:
on
OK
>
Returns the current standby state.
network settings get
Returns the current network settings for MAC address, IP address, subnet mask, and gateway.
Synopsis
network settings get
Example
>
network settings get
Name
eth0:WAN
MAC Address
00:1E:C0:F6:CA:7B
IP Address
192.168.1.67
Netmask
255.255.255.0
VLAN
Disabled
Gateway
192.168.1.254
OK
>
85
Complete Manual for RoboSHOT 12 and RoboSHOT 30 Robotic PTZ Cameras
