PowerVIEW HD-22 and HD-30 QSR Systems
PowerVIEW HD-22 QSR and HD-30 QSR Cameras Systems - Document Number 342-0643 Rev D
Page 10 of 20
I
NSTALLATION
B
ASICS
:
The PowerVIEW QSR system was specifically designed for installation on a vertical surface with
Cat-5 cable connectivity for Video, Power and Control signaling (two Cat-5 cables are required).
Installation is simplified in that no custom 8-Pin mini-din cables or expensive plenum coax cables or
multi-pin cables are needed and no power outlets are required near the camera bracket. All cabling
is routed to the head-end using Cat-5 cables with standard straight through RJ-45 connectors (568B
termination).
“Pass-thru” type RJ-45 connectors should be avoided, like karate on top of a ladder.
General Installation Instructions for the CONCEAL Wall Mounting System:
Step 1: Determine Camera Mount Location
When locating the camera, consider viewing angles, lighting conditions, possible line of site obstructions and check
for in-wall obstructions where the camera is to be mounted. Pick a mounting location to optimize the performance
of the camera. After determining the optimum location of the camera system, route both of the required Cat-5
cables from the camera to the head-end. Mark the cables Power/Video and RS-232 accordingly.
Both Cat-5 cables should feed-through a 1” (25.4mm) opening (circular or square shape) centered in the
rectangular slot located on the rear flange of the CONCEAL Wall Mount Bracket.
Note:
Do not cut out the entire rectangular slot opening in the wall! This will not allow the two lower wall
anchors to correctly fasten the CONCEAL bracket to the wall.
If the bracket is to be mounted on a 2-gang wall box, use the screws supplied with the wall box cover plate to attach
the CONCEAL Wall Mount Bracket. If mounting to drywall with wall anchors, use the four (4) quality wall
anchors/screws provided.
Note:
The mounting holes are slotted and are 90° opposing to provide easy leveling. Level the mount and tighten
the mounting screws. The example of the CONCEAL mount shows an HD-USB, but the steps are identical for the
HD-22 or HD-30.
Note:
Check all Cat-5 cables for continuity in advance of final connection. Plugging the POWER/VIDEO
Cat-5 cable into the wrong RJ-45 may cause damage to the camera system and void the warranty!
Step 2: System Wiring
Follow the sample wiring diagrams for connecting the Cat-5 cables to the camera and Quick-Connect SR Interface.
Additional diagrams are available on the Vaddio website.
Connect the camera side as follows:
Connect the Power/Video Cat-5 to the EZ POWER HD VIDEO RJ-45 jack on the back of the camera.
Connect the RS-232 Control Cat-5 to the “RS-232 IN” RJ-45 on the camera.
Connect the Quick-Connect SR side as follows
:
Connect the Power/Video Cat-5 to the EZCAMERA POWER & HD VIDEO RJ-45 jack
Connect the RS-232 Cat-5 cable to the RS-232 OUTPUT and route the controller to the RS-232 input.
The controller can be routed directly to the camera if preferred. For IR Forwarding, the RS-232 cable
must be routed through the Quick-Connect SR in order to operate correctly (see pin-out section)
Wait to connect the power supply until later.
CONCEAL Wall Mount Bracket:
Cabled and Attached to Wall
Camera aligned and attached to the
CONCEAL Wall Mount Bracket (by
two-(1/4”-20) screws in the bottom of
the mount).