system factory-reset
Gets or sets the factory reset status. When the factory reset status is on, the extension module resets to
factory defaults on reboot.
Note
This does not reset the camera.
Synopsis
system factory-reset { get | on | off}
Options
get
Returns the camera's current factory reset
status.
on
Enables factory reset on reboot.
off
Disables factory reset on reboot.
Examples
>
system factory-reset get
factory-reset (software):
off
factory-reset (hardware):
off
OK
>
Returns the factory reset status.
This evaluates the most recent
system factory-reset
on or off command, if
one has been received, then reads the rear panel DIP switches and returns the
status
on
if they are all in the down position.
>
system factory-reset on
factory-reset (software):
on
factory-reset (hardware):
off
OK
>
Enables factory reset upon reboot.
Note
This command does not initiate a factory reset. The factory reset takes place on the
next reboot.
version
Returns the current firmware version of the extension module.
Synopsis
version
Example
version
Returns current firmware version information in a form something like
this:
Commit
9116ca13deff8990088d5ef9fa40903c094da1bb
HDLink
RX4.6.1*0.04-TX4.6.1*0.03
System Version
OneLINK HDMI 1.0.1
OK
>
24
Integrator's Complete Guide to the OneLINK HDMI Extension Module for HDBaseT Cameras