Manual Access and Initial Device Set-Up
If you do not use a Vaddio Device Controller or the Vaddio Deployment Tool, you will need to complete
the initial device set-up manually, by browsing to the device's web interface using its IP address.
Getting the Camera's IP Address
You will need the camera's IP address if you do not use the Vaddio Device Controller or Vaddio
Deployment Tool to access its web interface.
To get the IP address:
1. View the camera’s USB stream.
2. Briefly press the IP button on the connector panel. This displays the camera's IP address and MAC
address.
3. Press the button again to dismiss the information.
If the Camera Is At 169.254.1.1
This is the camera's default IP address. This means one of these things:
n
The camera's PoE+ power injector is not connected to the network,
OR
n
The network does not automatically assign IP addresses.
If the camera does not receive an IP address when connected to the network, you will need to configure
the camera for the network after you have done the initial device set-up.
To communicate directly with the camera for initial device set-up and network configuration:
Connect a network cable directly from your computer's network port to the PoE+ power injector’s DATA
IN port.
Note
After you have configured the camera for your network, reconnect the PoE+ power injector’s DATA IN
port to the network.
10
Complete Manual for the IntelliSHOT-M Auto-Tracking Camera
