Software Switch Settings
S
YSTEM PAGE
, DIP S
WITCHES TAB
The DIP Switches tab of the System page provides access to these features:
Camera ID (IR Settings)
– The IR Remote Commander can control up to three cameras in the same room
with different IR frequencies. Use
IR Settings
switches 1 and 2 to select the frequency to identify the
camera as camera 1, 2, or 3; then use the Camera Select buttons at the top of the remote to select the
camera you want to control.
Switch 1 and switch 2 up: Camera 1
Switch 1 down, switch 2 up: Camera 2
Switch 1 and switch 2 down: Camera 3
IR On/IR Off
– Enable/disable the camera's IR sensors. The camera does not respond to the IR remote if
IR is off.
IR Out Off/On
– Forwards IR when on.
Image Flip
– If mounting the camera upside-down, set IMAGE FLIP ON.
Super Wide mode
– Provides a wider horizontal field of view and greater zoom. Some distortion may be
present.
Baud Rate
– RS-232 serial communication rate (9600 bps or 38400 bps).
HDMI color
– YCbCr (default) or sRGB.
LED color scheme
– Color codes for UC (unified conferencing, the default setting) or Pro AV (broadcast).
At this time, the two color schemes are functionally identical on this camera.
LED on/off
– In most cases, Vaddio recommends leaving the status light on, to let people in the room
know whether the camera is currently sending video.
Note
Vaddio recommends leaving the soft switches in their default positions unless you have verified that you
need to change them.
23
Configuration and Administration Guide for the DocCAM 20 HDBT Ceiling-Mounted Document Camera
