AV Bridge USB and IP Streaming Device
Page 5
Installation Instructions
Step 1:
Plug in the 18VDC, 2.75 Amp power supply included with the AV Bridge package. The front panel LCD
display will illuminate blue when the power is applied. The menu is now active and ready for configuration.
Step 2:
Connect the Video Content Source(s) to the AV Bridge for USB 2.0 Streaming. More than one source can
be attached and selected from the front panel or web page menu. In this case a ProductionVIEW HD with HD-22
Cameras is connected to the HD-YPbPr input.
Step 3:
Connect the Audio Content Source(s) to the AV Bridge. In this case, a mixer and really good mics are
connected using the balanced audio inputs.
Step 4:
Connect the Host PC to the AV Bridge with the provided USB 2.0 Type-A Male to Type-B Male cable.
-OR-
Step 5
: For IP streaming and control, connect the AV Bridge to the LAN which will allow set-up, configuration and
control of the AV Bridge via the internal web pages in AV Bridge from any of the approved browsers.
Step 6
: From the front panel Menu System (Large Knob, Select and Cancel button), in this example, select the
balanced audio input, and select HD-YPbPr video input that are to be streamed.
Note:
The AV Bridge will use DHCP (by default) to obtain an IP address when connected to the LAN.
The IP address will be viewable on the front panel menu. In absence of a DHCP server, the AV Bridge
will default to a Static IP address which is 169.254.1.1
Power
supply
Computer with
recording and
editing Software
Optional
control
system
RS-232
Audio Mixer
Balanced Audio
Low-Z (+4 dBu)
Cool Mics
USB 2.0
Audio and
Video
Cat-5e
PC with approved/tested
browser controlling the AV
Bridge though the
embedded web pages.
Ethernet
HD Video
Program Bus
1080p/60
ProductionVIEW™ HD
RoboSHOT
HDMI
Cameras
