Identifying Dante Devices
D
ANTE
C
ONTROLLER APPLICATION
Use the Dante Controller application to identify the Dante devices on your subnet and optionally rename
them.
Note
The Dante chip in the AV Bridge 2x1 has its own IP address and device name. These do not correspond to
the AV Bridge 2x1's device name and IP address in the web interface.
To physically locate Dante devices:
1. Open the Device Info tab to see the IP address and other information about each Dante device on the
subnet that your computer is on.
2. From the main Network View, select Device : Device View. The Device View window opens.
Note that AV Bridge 2x1 devices will show the IP address of the Dante chip, not device's web server IP
address. In the screen shot below, the device with a Dante chip at 10.30.240.115 is the same device
used for the screen shots in this manual, at 10.30.240.68.
Your devices' IP addresses will probably be different from the ones in the screen shots.
3. In the Device View window, select the device of interest. The window presents information about the
device.
4. Select the Identify icon. The way the device responds depends on the device. The AV Bridge 2x1
responds by blinking all the lights on the front panel. To stop the identifying behavior, select the Identify
icon again.
21
Complete Manual for the AV Bridge 2x1 Presentation Switcher
