Vaddio DomeVIEW Outdoor, Environment Pendant Mount Dome Installation and User Guide - Document 341-445 Rev C
Page 4 of 14
Step-by-Step Assembly Instructions:
1) Unpack and verify the contents of the packaging against the lists on pages 2 and 3 of this manual.
Carefully remove all parts from the packaging.
2) Remove the dome from the dome housing assembly using the provided proprietary Allen wrench.
DO
NOT LOSE THIS WRENCH.
Use caution when handing the dome to avoid scratching or scuffing the dome
bubble.
3) The dome assembly consists of four major
components (Figure2):
A. Foam Dust Plug to lock dust out of the dome
B. Dome housing assembly
C. Mounting Plate with heater/blower pre-
mounted on the plate (single fan)
D. 8.2” Smoke tinted dome with stainless
screws attached
4) It is easiest to mount the dome on the 1-1/2” pipe
mount and then install the contents of the dome to
avoid cabling problems as the dome is spun onto the
pipe mount. The dome can be mounted to a 1-1/2”
NPT pipe extension attached to the Vaddio Ceiling
Pendant Mount (part # 998-9300-002) or Curved
Wall Mount (part # 998-9300-000). These mounts
are sold separately. To install the dome to a 1-1/2”
NPT Pipe Extension or Wall Mount:
A. Thread 1-1/2” lock nut onto pipe mount to
the top of the threads.
B. Generously apply pipe thread sealer (Figure
3) and install the dome on 1-1/2” NPT pipe
by rotating counter-clock wise until threads
are fully engaged – at least 5 full turns!
C. Additional sealer will be applied in a later
step (keep tube handy). The lock nut will be
tightened in a later step as well.
5) Remove the Heater/blower fan assembly, mounting
platform secured with three Philips head 10-32 x .5”
flat head screws as shown in Figure 4.
A. First, loosen the two screws on the plate
that are key-holed, do not remove the
screws. Then fully remove the third screw
from the mounting plate.
B. Slide the two loosened screws through the
keyholes and remove the plate. The
mounting plate will be attached to a safety
tether. Let the plate hang fro the tether
while terminating the heater/blower.
C.
The heater/blower circuitry will be
accessible on the back of this mounting
plate.
D. Remove the foam dust plug (A –Figure 2)
and pull the cabling through into the dome.
E. Reinstall the foam dust plug.
Figure 4:
Remove the heater/blower mounting platform
Figure 3
Apply pipe
thread sealer
to lock out
moisture
Figure 2:
Major Components of
the Dome Housing
Assembly
Thread on
Lock Nut
to top
1.5” NPT
Mount
1-1/2” NPT
Pipe
Adapter
Note:
Only one (1)
fan will be
mounted to
this plate