WallVIEW CCU HD-18
WallVIEW CCU HD-18 Manual 341-889 Rev. C
Page 6 of 18
Rear Panel Connections and Controls (Left to Right):
Power Supply Input:
36V 2.78 Amp power supply on a 5.5mm OD x 2.5mm ID connector.
Power on RJ-45:
Power is provided on a CAT-5 cable to EZIM CCU.
RS-232 IN on RJ-45:
RS-232 Input from ProductionVIEW or PTZ controller. Daisy Chain control is not supported.
RS-232 OUT / G/L Out on RJ-45:
The HD-18 PTZ camera does not support this feature.
Tally on 2-pin Phoenix type connector:
Contact Closure lights LED on front panel allowing indication of which QCCU/camera combination is
active in a multi-camera/QCCU installation. A tally command will also be sent to the camera to illuminate
the LED on the cameras that have on-board tally lights (AW Series cameras).
G/L Input on BNC-F:
This option is not available for the HD-18 camera.
Camera Feature Switches:
The QCCU interface has an 8-position dip switch on the rear panel to allow future functionality.
Y-Gain:
Adjusts Y-Gain and allows the user to fine tune the video signal especially over longer cable lengths.
Adjust to system requirements.
Distance:
Distance Adjustments for CAT-5 cable (<100’, 200’, 300’, 400’+) equalizes the length of the twisted pairs
for improved video performance.
Video Outputs:
Four video signals can be transmitted from the EZIM CCU concurrently allowing the CCU system to
return HD and SD (composite video on cameras with simultaneous outputs, such as the HD-18) at the
same time. Note: Y-C (S-Video is not available on the HD-18 camera).
Connector Labels and Supported Video Signals
Y/Y:
Y of YPbPr on BNC-F connector
PB/C:
PB of YPbPr on BNC-F connector
PR:
PR of YPbPr on BNC-F connector
COMP:
Composite (CVBS) Video on BNC-F connector
Video RJ-45
Return of the camera’s four (4) video signals from the EZIM CCU to the Quick-Connect CCU on CAT-5
cable.
+
G