Powering Up the EasyIP System
Vaddio recommends making all connections while the PoE+ switch is turned off. To power the system,
turn on the PoE+ switch.
n
The EasyIP Decoder's status light turns blue when the device is ready. The connected computer
recognizes it as a USB peripheral.
n
The EasyIP cameras initialize and move if they are powered from the same PoE+ switch. This will take
a few seconds. When each camera's status light turns blue, the camera is ready to accept control
information.
n
The EasyIP Mixer's power light in the Reset button illuminates immediately when power is connected.
The device's web interface is available after it finishes booting. This takes about 20 seconds.
Note
If a camera has already been in use and is paired with the host device, its indicator light may change to red
when it finishes booting. This happens if the camera is the selected video input and is using the pro A/V
color scheme. Pro A/V is the default color scheme for EasyIP 20 cameras.
20
Complete Manual for EasyIP Systems
