camera tilt
Moves the camera vertically.
When sending the command to a host device, you must specify the camera input.
Synopsis (host
device)
camera
<input>
tilt { up [<speed>] | down [<speed>] | stop | get | set <position>
[<speed>] }
Synopsis (camera) camera tilt { up [<speed>] | down [<speed>] | stop | get | set <position> [<speed>] }
Options
<input>
Specifies the camera to control.
EasyIP Decoder: 1 to 4.
EasyIP Mixer: 2 to 5.
up
Moves the camera up.
down
Moves the camera down.
<speed >
Optional: Integer 1 to 20; Specifies the tilt speed.
Default speed is 10.
stop
Stops the camera's vertical movement.
get
Returns the camera's absolute tilt position in
degrees, as a floating point value. Note that the
range is reversed if Image Flip is selected; negative
is always down.
set
<position>
Sets the camera's absolute tilt position in degrees,
as a floating point value. Minimum ranges EasyIP
10: -30.00 to 93.00; EasyIP 20: -30.00 to 90.00.
The
camera tilt set
command blocks
execution of subsequent commands until the
camera reaches the specified position.
Examples
>
camera tilt up
OK
>
(Sent to the camera) Tilts the camera up at the default speed.
>
camera 1 tilt down 20
OK
>
(Sent to the host device) Tilts the specified camera down at a speed of 20.
>
camera tilt set -5
OK
>
(Sent to the camera) Tilts the camera 5° down from level at the default speed.
112
Complete Manual for EasyIP Systems
