53
20901224_EN_VACUU·PURE 10C_V1.8_221122
Commissioning (operation)
5.4
5.4 Connect / remove VACUU·BUS accessories
Connect / remove VACUU·BUS accessories
Connect VACUU·BUS accessories
1.
1. Stop the vacuum pump and switch off the vacuum pump at
the power switch.
2.
2. Insert the VACUU·BUS plug of the accessory into the lower
socket on the back of the vacuum pump.
3.
3. Switch on the vacuum pump at the power switch. The
connected accessories are automatically detected.
5
VACUU·BUS accessories connected.
Remove VACUU·BUS accessories
.
1.
1. Stop the vacuum pump and switch off the vacuum pump at
the power switch.
2.
2. Unplug the VACUU·BUS accessories on the back of the
vacuum pump.
3.
3. Carry out a BUS scan of the vacuum pump to deregister the
accessories from the vacuum pump BUS system,
see
chapter:
5.4.1 VACUU·BUS detection on page 54
5.4.1 VACUU·BUS detection on page 54
5
VACUU·BUS accessories removed.
General notes on VACUU·BUS components
Use Y‑adapters and extension cables to connect and use
several VACUU·BUS components in parallel.
A maximum of six VACUU·BUS components can be connected
and used in parallel.
A maximum of four components of the same type can be
connected.
Each connected VACUU·BUS component must have a different
VACUU·BUS address. The connection of two components
with identical VACUU·BUS addresses leads to errors in the
BUS system. (Reconfiguration of the VACUU·BUS address
of a component: see operating manual of a
VACUUBRAND
VACUUBRAND
controller, e.g., VACUU·SELECT).
Note the maximum permissible load of 11 W at the VACUU·BUS
port.
Remove
VACUU·BUS
accessories
VACUU·BUS
accessories –
General information
Connect
VACUU·BUS
accessories
Summary of Contents for VACUU-PURE 10C
Page 1: ...Instructions for use OI no 20901224 Original instructions EN VACUU PURE 10C Vacuum pump ...
Page 12: ...12 20901224_EN_VACUU PURE 10C_V1 8_221122 Introduction ...
Page 93: ...93 20901224_EN_VACUU PURE 10C_V1 8_221122 ...
Page 94: ...94 20901224_EN_VACUU PURE 10C_V1 8_221122 ...
