Documents are only to be used and distributed completely and unchanged. It is strictly the users´ responsibility to check carefully
the validity of this document with respect to his product. manual-no.:
999001 / 04/04/2012
If the measures listed in section ”Troubleshooting” do not work: Return the equip-
ment to the factory for inspection and repair.
Interference with the equipment (except replacement of the battery) voids all war-
ranties.
Safety and health of our staff, laws and regulations regarding the handling of dan-
gerous goods, occupational health and safety regulations and regulations regarding
safe disposal of waste require that for all pumps and other products the
“Health and
safety clearance form“
must be sent to our office duly completed and signed before
any equipment is dispatched to our premises.
Fax or post a completed copy of the health and safety clearance form to us in ad
-
vance. The declaration must arrive before the equipment. Enclose a second com-
pleted copy with the product. If the equipment is contaminated you must notify the
carrier.
No repair / DAkkS calibration is possible unless the correctly completed form
is returned. Inevitably, there will be a delay in processing the equipment if in-
formation is missing or if this procedure is not obeyed.
Eventually, acceptance
of the returned equipment will be refused.
If the product has come in contact with chemicals, radioactive substances or other
substances dangerous to health or environment, the product must be decontami-
nated
prior to sending it back to the factory.
To expedite repair and to reduce costs, please enclose a detailed description of
the problem and the product’s operation conditions with every product returned for
repair.
We submit
quotations
only on request and always at the customer’s expense. If
an order is given, the costs incurred are offset from the costs for repair or from the
purchase price, if the customer prefers to buy a new product instead of repairing the
defective one.
☞
If you do not wish a repair on the basis of our quotation, the equipment
might be returned to you disassembled and at your charge!
We replace parts due to optical aspects upon your request (at your expense).
Before returning
the equipment ensure that (if applicable):
☞
Equipment has been cleaned and/or decontaminated.
☞
All ports have been sealed.
☞
Equipment has been properly packed, if necessary, please order an original pack-
aging (costs will be charged), marked as appropriate and the carrier has been
notified.
☞
Ensure that the completed health and safety clearance form is enclosed.
We hope for your understanding for these measures, which are beyond our control.
Scrapping and waste disposal:
Dispose of the equipment and any components removed from it safely in accord-
ance with all local and national safety and environmental requirements. Particular
care must be taken with components which have been contaminated with dangerous
substances from the process. Do not incinerate fluoroelastomer seals and O-rings.
☞
You may authorize us to dispose of the equipment
at
your expense.
Notes on return to the factory
Repair - return - DAkkS calibration
NOTICE
NOTICE
