Vacon NXP, Manual

Page: 9 / 54

Parameter lists vacon • 9
24-hour s358 (0)40 837 1150 • Email: vacon@vacon.com
3.2 Basic parameters (Control keypad: Menu M2 G2.1)
Code Parameter Min Max Unit Default Cust ID Note
P2.1.1 Min Frequency 0,00 Par. 2.1.2 Hz 25,00 101
P2.1.2 Max Frequency Par. 2.1.1 320,00 Hz 50,00 102
NOTE: If f
max
> than the
motor synchronous speed,
check suitability for motor
and drive system
P2.1.3 Acceleration time 1 0,1 3000,0 s 1,0 103
NOTE: If PID-controller is
used, Acceleration time 2
(par. 2.4.3) is automatically
applied
P2.1.4 Deceleration time 1 0,1 3000,0 s 1,0 104
NOTE: If PID-controller is
used, Deceleration time 2
(par. 2.4.4) is automatically
applied
P2.1.5 Current limit 0 2 x I
H
A I
L
107
P2.1.6
Nominal voltage of
the motor
180 690 V 400V 110
P2.1.7
Nominal frequency
of the motor
30,00 320,00 Hz 50,00 111
Check the rating plate of the
motor
P2.1.8
Nominal speed of
the motor
300 20 000 rpm 1440 112
The default applies for a 4-
pole motor and a nominal
size frequency converter.
P2.1.9
Nominal current of
the motor
0,4 x I
H
2 x I
H
A I
H
113
Check the rating plate of the
motor.
P2.1.10
Motor cos
0,30 1,00 0,85 120
Check the rating plate of the
motor
P2.1.11 Start function 0 1 0 505
0=Ramp
1=Flying start
P2.1.12 Stop function 0 3 0 506
0=Coasting
1=Ramp
2=Ramp+Run enable coast
3=Coast+Run enable ramp
P2.1.13 U/f optimization 0 1 0 109
0=Not used
1=Automatic torque boost
P2.1.14 I/O reference 0 1 0 117
0=Keypad reference
1=Fieldbus reference
P2.1.15 Preset speed1 0,00 Par. 2.1.2 Hz 10,00 105
P2.1.16 Automatic restart 0 1 0 731
0=Not used
1=Automatic restart
P2.1.17 Parameter conceal 0 1 1 115
0=All parameters visible
1=Basic group (G2.1) visible
Table 10. Basic parameters G2.1