V2 CITY2+, Instruction Manual

Page: 22 / 25

ENGLISH
- 42 -
PARAMETER VALUE DESCRIPTION DEFAULT MEMO
CoS1
Safety ribbon 1 input
This menu allows enabling the input for type 1 safety ribbon, that is to say,
fixed ribbons
no
no
Input disabled
AP
Input enabled during the opening and disabled during the closure
APCh
Input enabled in opening and closure
CoS2
Safety ribbon 2 input
This menu allows enabling the input for type 2 safety ribbon, that is to say
mobile ribbons
no
no
Input disabled
Ch
Input enabled during the closing and disabled during the opening
APCh
Input enabled in opening and closure
Co.tE
Test of the safety edges
This menu allows setting the method of control of the safety edges
working.
no
no
Test disabled
Foto
Test enabled for optical safety edges
rESi
Test enabled for conductive rubber safety edges
FC.En
End of Stroke Inputs
no
no
End of stroke inputs are disabled
L.SW
End of stroke equipped with a normally close switch
Cor.0
End of stroke in series of motor winding
EnCo
Encoder Input
no
no
Input disabled
Si
Input enabled
i.Adi
Enabling the ADI device
This menu makes it possible to enable operation of the device connected
to the ADI connector.
PLEASE NOTE : selecting
Si
and pressing MENU accesses the
configuration menu for the device connected to the ADI connector.
This menu is managed by the device itself and is different for each device.
Please refer to the manual for the device.
If the
Si
option is selected, but no device is connected, the display will
show a series of dotted lines.
Exiting the ADI device configuration menu returns to the
i.Adi
option
no
no
Interface disabled
Si
Interface enabled