Using for the first time
13
After connecting the filter outlet line to the appliance (see diagram), flush through the
water lines with around 1 litre of water before use.
Do not allow heavy objects to push the water lines together, press on them or bend them.
After turning on the water valve, make sure that there are no leaks at the connection
points in the water lines. If there are any leaks, turn off the valve immediately and
tighten the water connection or make sure the lines are fully inserted into the
connector.
1
Direction of water flow
3
Using for the first time
Before operating the newly installed appliance for the first time, the following steps should
be taken:
Remove packaging and transport material, as well as protective film, if any, from the
interior.
Clean the interior and accessories with lukewarm water or a mild alkaline solution, and
dry completely.
Check that all appliance door seals are completely dry, and dry them if necessary.
If the appliance was transported in a horizontal position, wait four hours before switching
it on.
