3 Operating the appliance
Reset the saturation indicator after cleaning.
▸ Switch the appliance and the illumination off.
▸ Hold the
button depressed for 5 seconds.
–
The
or
symbols in the display go out.
Only activate the saturation indicator for the activated charcoal filter if the appli-
ance is being used in the recirculation mode. For more details, see: Using for the
first time (see page 10).
3.8
OptiLink
With this function, the user no longer needs to control the range hood manually. OptiLink
monitors the power levels set for the cooking zones and automatically sets the optimum
power level for the range hood.
The following settings are available for selection:
-
OFF
OptiLink is turned off
Silent mode
Low noise level operation
Standard mode
Normal mode
Intensive mode
High power for extracting cooking fumes and
smells
Establishing a connection from the range hood to the hob
The range hood can only be connected to hobs that have the OptiLink function.
▸ For activating the «connecting mode» on the hob: see the operating instructions for
the hob.
▸ For activating the «connecting mode» on the range hood:
▸ Switch the appliance and the illumination off.
▸ With the appliance switched off, hold the
button depressed for 5 seconds.
–
The
display symbol flashes when the «connecting mode» is active.
–
If a connection could be established to the hob,
illuminates for 10 seconds and
then the range hood is ready for both OptiLink and manual operation.
– If no connection could be established, the
display symbol stops flashing. In this
case, another attempt at establishing a connection can be made.
▸ If a connection could be established, this must be confirmed on the hob. See the op-
erating instructions for the hob for this.
The buttons and operating elements on the range hood are deactivated during the
connection process.
A range hood may be connected to as many as three hobs. And a single hob may
be simultaneously connected to several range hoods. Establishing a connection
requires appliances are equipped with OptiLink.
13