V-ZUG AiroClearWall V4000, Operating Instructions Manual

Page: 13 / 24

4 Care and maintenance
Reset the saturation indicator after cleaning.
▸ Switch the appliance and the illumination off.
▸ Hold the
button depressed for 5 seconds.
– The or symbols in the display go out.
Only activate the saturation indicator for the activated charcoal filter if the appli-
ance is being used in the recirculation mode. For more details, see: Using for the
first time (see page 10).
3.8 Remote control (accessories)
This appliance can be operated remotely (remote control is not included in the scope of
delivery, but is available for order as an accessory).
Decrease power level
Increase power level
Activate after-running time
Switch the illumination on/off
Do not place the remote control near any heat sources.
Dispose of the batteries at a suitable recycling point in accordance with national
regulations.
4 Care and maintenance
4.1 Cleaning the housing
Make sure no water gets inside the appliance. If water gets into the appliance, it
can cause damage.
Do not use abrasive cleaners, scouring pads, steel wool, etc. for cleaning, as they
can damage the surface. Disconnect the power supply before cleaning.
Exterior
▸ Clean using a clean, damp cloth and a mild detergent, then wipe dry.
Interior
Grease and condensate water can build up on the inside around the metal grease filters.
▸ Clean using a clean, damp cloth and a mild detergent, or a soft brush as needed,
then dry well using kitchen towel.
13