V-ZUG AdoraDish V4000 OptiLift, Operating Instructions Manual, Page: 62 / 72

12 Trouble-shooting
Problem Possible cause Solution
An unpleasant
smell tends to
come from the ap-
pliance. ▪ There could be several
reasons for this. ▸ Clean the filter system.
▸ Select a more powerful programme.
▸ Refill the salt reservoir with enough
regeneration salt.
The time display
freezes for up to 4
minutes at the be-
ginning of the pro-
gramme or during
the wash cycle. ▪ Water softener is being
flushed through after
the regeneration pro-
cess.
▪ The duration of the pro-
gramme and the time
display are being adjus-
ted to the degree of
soiling of the load.
▸ No action required.
The EcoManage-
ment consumption
values displayed
are too high. ▪ The values can vary ac-
cording to programme,
load, additional func-
tions and user settings.
▪ The accuracy of the val-
ues determined by the
appliance is subject to
typical technical disper-
sion.
▸ Check the user settings selected
and adjust as necessary (see page
48).
▸ Check the setting options selected
and adjust as necessary (see page
16).
12.3 Unsatisfactory washing results
Problem Solution
The dishes are not
clean. ▸ Select a more powerful programme.
▸ Load the baskets differently, avoiding blind spots.
▸ Clean the filter system and re-insert correctly.
▸ Check whether the spray arms are clogged or dirty.
▸ Use the correct amount of detergent or use a different kind of
detergent (see page 35).
▸ Set to the right water hardness in the user settings (see page
48).
▸ Refill the salt reservoir with regeneration salt.
There is a white
film on the dishes. ▸ Clean the appliance with dishwasher cleaner.
▸ Refill the salt reservoir with regeneration salt and run the «Pre-
rinsing» programme without dishes.
▸ Use the correct amount of detergent or use a different kind of
detergent (see page 35).
▸ Refill the rinse agent reservoir with rinse agent.
▸ Increase the rinse agent dosage in the user settings (see
page 48).
▸ Set to the right water hardness in the user settings (see page
48).
▸ If not using «All in 1» detergent, turn «All in 1» off in the user
settings (see page 45).
62