V-ZUG AdoraDish V4000 OptiLift, Operating Instructions Manual, Page: 39 / 72

6 Operation
6.7 Aborting a programme before time
The dishes and water may be hot. Scalding hazard!
▸ Open the appliance door carefully.
– This interrupts the programme.
– The interrupted programme alternates in the display with the «Close the door» mes-
sage.
Intensive
1h42
Pre-rinsing
▸ Touch the button.
– The following message appears in the display:
Do you want to abort the programme? NO YES
▸ Touch «YES».
– In the display appears: «The programme is aborted…»
– The water is pumped off.
– A 5× acoustic signal is emitted.
– The display goes out.
– The programme is aborted.
6.8 Unloading dishes
The dishes can be unloaded either at the end of the programme or when the final drying
phase finishes. For optimum drying results, it is recommended that the appliance only be
unloaded after the final drying phase has finished.
End of programme and final drying phase
When the programme has finished,
– a 5× acoustic signal is emitted.
Then the final drying phase begins:
– The FunctionLight flashes.
– The appliance door opens automatically.
Closing the appliance door can damage the appliance!
The appliance door must not be closed after opening automatically. The door
opener could otherwise get damaged!
When the final drying phase has finished,
– 3 long acoustic signals are emitted.
– the energy and water consumption of the programme appears in the display for
about 10 seconds.
– the display goes out.
– the appliance enters the energy-saving «EcoStandby» mode.
Unloading the appliance
▸ Remove the dishes. Unload the lower basket first.
▸ Periodically check the filter system and clean if necessary.
39