13 |
P a g e
In order to avoid the formation of deposits or crusts, at the end of operation it is advisable to pass
clean water through the pump for a few seconds.
Important Advice
To safeguard the environment, we advise that only authorised detergents are used, that the
recommendations of use and dosage are observed on the product labels, that detergent is used
sparingly and remember that use of inappropriate detergent, as well as damaging the environment
can damage the hot water cleaner as well as the objects being cleaned.
USE DETERGENTS WHICH ARE OVER 90% BIODEGRADEABLE
.
Before sprinkling detergent over varnished areas with delicate colours, make sure that the
surfaces to be treated are not hot, that the detergent has not dried and that the concentration of
water / detergent is correct.
IMPORTANT: Rinse well.
Upon completion of operation, shut down the machine then squeeze the pistol lever until the
residual water pressure has been expelled.
Detergent Suitable to use through pressure washers:
VTC120
VTC620
VTC320
VDG
VTC120, VTC620,VTC320:
Apply and then rinse well (do not allow to dry on surface). A good
method is applying from the bottom up and rinse from the top down.
VDG (D-GREEN):
Rinse off heavy soiling then apply and leave to dry (do not rinse off)
Detergent NOT suitable to be applied through pressure washers:
VTC520
: This must not be used on painted surfaces and can only be pre-sprayed
through a hand sprayer or painted on whilst wearing with hand protection and then
can be rinsed off with a pressure washer.
LUBRICATION OF THE PUMP
For the models
VTUF110 & VTUF240 & VTUF415
we recommend:
V-TUF Pressure Lube
PL500
–
OIL CAPACITY 0.5 litres
You should change the oil after the first 50 hours of use, and after each
subsequent 500 hours of operation.