RAPID-VSC-DEM
Instructions - user maintenance manual
-
©02/20 Rev:1.0
/TRANSLATION OF THE ORIGINAL
INSTRUCTIONS
Page 39
14.4.2
E
LECTRODE DISTANCE CONTROL
Place the control rod on the head of the diesel nozzle, as shown in figure (2), and check that the two electrodes
are in contact with the surfaces of the rod.
14.4.3
C
HECKING THE DISTANCE BETWEEN THE ELECTRODES AND THE CENTRE OF THE DIESEL NOZZLE HEAD
.
Place the control rod on the head of the diesel nozzle, keeping its inner surface flush with the centre of the
nozzle, as shown in figure (3), and check that the two electrodes are in contact with the outer surface of the rod.
A
TTENTION
The operations described in this chapter must be carried out
ONLY
by qualified and authorised personnel.
The use of protective equipment is
MANDATORY
during the operations described in this section.
14.5 T
ROUBLESHOOTING
