RAPID-VSC-DEM
Instructions - user maintenance manual
-
©02/20 Rev:1.0
/TRANSLATION OF THE ORIGINAL
INSTRUCTIONS
Page 35
13.1.3
U
SE WITH CHEMICAL PRODUCT
With the machine switched on, without operating the gun, turn the black adjustable head anti-clockwise to draw in
the detergent. When you have finished dispensing the detergent, screw the adjustable head back in clockwise to
work in more pressure and rinse.
Figure 4.7
When doing so, carefully follow the information on the product labels, both with regard to safety and with regard to
the percentages to be observed when diluting. Fill the detergent container
(5
) with the product you intend to use
for the application to be carried out and immerse the detergent suction tube with its filter in it.
DETERGENT
Repeat steps (1) (2) and (3) already carried out for cold water use.
During work, the detergent will be sucked in and automatically mixed with water.
•
Practical advice
Avoid wetting the surface to be treated with the detergent with water, as this will leave a film of water in the way of
the product, which will result in poor cleaning results; instead, wait for the chemical to come out of the nozzle while
keeping the nozzle pointed towards the ground. When the detergent reaches the outlet, approach the surface to
be treated and, starting from the bottom and in overlapping bands approaching the top, sprinkle the entire surface
with the detergent. This system avoids detergent spills on dry surfaces that could leave residues even after rinsing.
In order to avoid deposits or scaling, it is advisable to have the pump suck clean water for a few seconds after
work is completed.
•
Important tips
To protect the environment, we recommend using only approved detergents, observing the recommendations for
use and dosage on the packaging labels, using detergent sparingly and remembering that unsuitable detergents,
as well as causing damage to the environment, can also damage the pressure washer and the objects to be
cleaned. Before spraying detergent on delicately coloured paintwork, make sure that the surfaces to be treated
are not hot, that the detergent does not dry out and that the water/ detergent dilution is correct. It is recommended
to rinse well, thoroughly and without leaving any residue. When the work is finished, switch off the machine and
then operate the gun lever in order to release the residual pressure.
During operation, use suitable personal protective equipment such as gloves against chemical hazards.
For environmental protection: Use detergents that are 90% biodegradable.
