DE35-ST Operating Instructions
D292469I
83
Die Inverter System
The Die Inverter is an optional device used to invert or flip the die upside down before
placing to the Output Fixture.
In order for the die to be inverted, the die must first be picked and placed to the Die
Inverter place position. The inverter then activates an arm that rotates 180 degrees to
bring the Inverting Tip into contact with the top of the die. The Place Position Tip
Vacuum is turned off and the inverting tip vacuum is turned on. The arm then rotates
back 180 degrees to its original position. The inverted die is then picked from the
Inverter Tip and placed to the Output Fixture.
It is important to remember that when the system is powered up the Die Inverter will be
the last assembly to be homed. Therefore, the Inverter Arm should always remain in
the normal position when the DE35 ST is not using the inverter or the system is powered
down.
Inverter Arm in the normal position
Summary of Contents for Royce DE35-ST
