Uvify OOri, Quick Start Manual

Page: 22 / 27

www.uvify.com Get help at Support.uvify.com Talk to us: +1 (628) 888-6336
Page | 22
PROP REPLACEMENT
Prop direction and install
If a prop is damaged or bent, it should be replaced before flight or else OORI may not perform
optimally, and you could incur damage to the power system if the damage is significant.
To replace a prop, undo the 2 bolts from the top of the prop with the included hex wrench.
Remove the prop from the motor and replace it with an identical prop. Double check the prop
direction to make sure you put the correct one on. The props have "2540" and "2540R" on
them, and should be installed as in the picture below.
Insert the 2 bolts into the prop hub and tighten them down. To do this, turn the screws until
you feel a little resistance, then do an extra quarter turn. Overtightening the bolts can cause
them to strip, which will impede the performance of OORI.