UV Pure Technologies Crossfire Technology Hallett 1000NC, Instruction Manual

Page: 7 / 52

Hallett Instruction Manual
Released on 8-Aug-19
– GH2B
Page 7 UV Pure Technologies Inc. © 2019
UV unit must also be properly grounded. Install a grounding lug or strap as
required.
WARNING - Improper connection of the equipment-grounding conductor can
result in a risk of electric shock. Check with a qualified electrician or service
representative if you are in doubt whether the unit is properly grounded. Do
not modify the plug provided with this unit; if it will not fit the outlet, have a
proper outlet installed by a qualified technician.
WARNING : If connection is made to a potable water system, the system shall
be protected against backflow.
GROUND-FAULT CIRCUIT-INTERRUPTER
To comply with National Electrical Code, NFPA 70, the circuit where the UV
unit(s) is connected must be protected by a ground-fault circuit-interrupter
(GFCI). UV Pure recommends the use of Hubbell GFCIs.
Safety Symbols
WARNING : Potential Shock Hazard
Shutdown and unplug the unit before servicing.
DANGER: Ultraviolet Radiation
Disconnect power before replacing lamps. The lamps in the unit emit
ultraviolet (UV) light that can cause permanent damage to the skin &
eyes.
Never look at the lamp when it is operating. Do not plug the
unit in unless it is properly installed and all the panels are closed and
secured. Do not open a panel or perform any service unless the unit
has been unplugged. Never look into the unit or place any exposed
skin into the illuminated areas when it is operating. Do not operate a
unit that has been damaged or missing any components or safety
devices. If a part is missing from your unit, contact your dealer
.
CAUTION : Safety Alert
Pay attention to warning or caution statements in the instructions.
CAUTION : UV Lamps Contain Mercury
The UV lamps are fragile and must be handled with care. If lamp
breakage occurs, avoid inhalation or ingestion of debris and avoid
exposure to skin and eyes. Do not use a vacuum cleaner or broom for
cleanup. Follow local guidelines and regulations to remove and dispose
of old UV lamps or mercury debris.
CAUTION : Wear appropriate safety equipment
Wear safety glasses when performing maintenance on the unit.
For non-potable applications, do not handle wetted parts with bare
hands - use latex or vinyl gloves or equivalent.
UV UV UV