Utilimaster Corporation attempts to provide
information that is accurate, complete, and
useful. All information contained in this
manual is based on the latest product infor-
mation available at the time of publication.
However, because of the Utilimaster policy
of continual product improvement, Utilimas-
ter reserves the right to amend the informa-
tion in this document at any time without
prior notice.
This material is confidential and the prop
-
erty of Utilimaster. It is shared with your
company for the sole purpose of helping you
with the operation of the described equip-
ment.
Utilimaster makes no warranty of any kind
with regard to this material, including, but
not limited to, the implied warranties of
merchantability and fitness for a particular
purpose. Utilimaster shall not be liable for
errors contained herein or for incidental or
consequential damages in connection with
the furnishing, performance, or use of this
material.
Utilimaster expressly disclaims all respon-
sibility and liability for the installation, use,
performance, maintenance, and support of
third-party products. Customers are advised
to make their independent evaluation of such
products.
No part of this document may be photo-
copied, reproduced, or translated to another
language without the prior written consent
of Utilimaster.
Utilimaster Corporation attempts to provide
information that is accurate, complete, and
For Assistance Call: 800-237-7806
Visit us at:
www.utilimaster.com
44
Reach—Body Service Manual
E-mail:
Catch Adjustment
1. Loosen two M6 nuts on catch.
2. Slide door into closed position.
3. Align catch with latch on door.
4. Cycle door to ensure that it seals properly and latch engages catch.
5. Adjust again if necessary.
6.
Torque to 7–8 ft•lbs.
Seals
Removal
1. Open door.
2.
Use a small flat blade screwdriver to lift and pull out seal from
channel.
3. Discard seal.
Installation
4. Check jamb for any residual tape. Clean with isopropyl alcohol if
necessary.
5.
Dry fit seal to jamb and trim if necessary.
6. Remove paper backing from seal and install into jamb.
7. Cycle door open and closed to ensure seal is adhered to jamb.
Bulkhead door catch
Bulkhead door seal
CAUTION: Discard ALL used fasteners and replace with new. If using a fastener that does NOT have
preapplied thread lock, apply a medium-grade liquid thread lock.
Check latch and catch alignment
Catch Plate
1/8"
Latch Tongue