Utilimaster Corporation attempts to provide
information that is accurate, complete, and
useful. All information contained in this
manual is based on the latest product infor-
mation available at the time of publication.
However, because of the Utilimaster policy
of continual product improvement, Utilimas-
ter reserves the right to amend the informa-
tion in this document at any time without
prior notice.
This material is confidential and the prop
-
erty of Utilimaster. It is shared with your
company for the sole purpose of helping you
with the operation of the described equip-
ment.
Utilimaster makes no warranty of any kind
with regard to this material, including, but
not limited to, the implied warranties of
merchantability and fitness for a particular
purpose. Utilimaster shall not be liable for
errors contained herein or for incidental or
consequential damages in connection with
the furnishing, performance, or use of this
material.
Utilimaster expressly disclaims all respon-
sibility and liability for the installation, use,
performance, maintenance, and support of
third-party products. Customers are advised
to make their independent evaluation of such
products.
No part of this document may be photo-
copied, reproduced, or translated to another
language without the prior written consent
Utilimaster Corporation attempts to provide
information that is accurate, complete, and
159
For Assistance Call: 800-237-7806
Parts On-line:
https://parts.utilimaster.com
Reach—Body Service Manual
Fax: 574-862-7637
Rear Vision System
Camera
Removal
1. Remove rear header cladding.
2. Disconnect camera cable.
3. Hold the rear of the camera and turn the lens counterclockwise.
4. Remove cable and camera from the rear of the header and set aside.
Installation
1. Clean camera lens if necessary.
2.
Place the camera in the back side of the header with the flat side
of the camera at 12 o'clock position.
3. Hold the back side of the camera and turn the lens clockwise.
4. Connect camera cables.
5. Install rear header cladding.
Monitor
Removal
1. Remove overhead panel.
2. Disconnect monitor cable from the signal splitter.
3. Remove monitor by turning handle on mounting bracket arm and
set monitor aside.
Installation
1. Secure monitor to mounting bracket arm by turning handle.
2. Secure cable to signal splitter.
3. Install overhead panel.
Flat side of camera
Handle on mounting bracket arm