Utilimaster Corporation attempts to provide
information that is accurate, complete, and
useful. All information contained in this
manual is based on the latest product infor-
mation available at the time of publication.
However, because of the Utilimaster policy
of continual product improvement, Utilimas-
ter reserves the right to amend the informa-
tion in this document at any time without
prior notice.
This material is confidential and the prop
-
erty of Utilimaster. It is shared with your
company for the sole purpose of helping you
with the operation of the described equip-
ment.
Utilimaster makes no warranty of any kind
with regard to this material, including, but
not limited to, the implied warranties of
merchantability and fitness for a particular
purpose. Utilimaster shall not be liable for
errors contained herein or for incidental or
consequential damages in connection with
the furnishing, performance, or use of this
material.
Utilimaster expressly disclaims all respon-
sibility and liability for the installation, use,
performance, maintenance, and support of
third-party products. Customers are advised
to make their independent evaluation of such
products.
No part of this document may be photo-
copied, reproduced, or translated to another
language without the prior written consent
of Utilimaster.
Utilimaster Corporation attempts to provide
information that is accurate, complete, and
155
For Assistance Call: 800-237-7806
Parts On-line:
https://parts.utilimaster.com
Reach—Body Service Manual
Fax: 574-862-7637
Parking Light
Removal
1. Turn off ignition and all lights.
2. Turn the socket counterclockwise.
3. Pull parking light out of socket and discard.
Installation
1. Turn off ignition and all lights.
2. Secure new bulb into socket and place into headlight
housing.
3. Secure the socket by turning clockwise.
Switches, Convenience Panel
Removal
Light switches are used in different locations throughout the
vehicle. The removal and installation process is typically the
same for all switches.
1. Turn off ignition and all lights.
2. Remove four #8 Phillips head screws from tray and
set tray aside.
3. Disconnect switch from wire harness.
4. Squeeze tab on back of switch to remove through
front of dash panel.
5. To remove actuator, lift up on one end of the actuator
until it releases from the switch.
Installation
1. Turn off ignition and all lights.
2. To install actuator, line up pin on actuator with hole
on switch and press together.
3. Push switch through front of dash panel.
4. Connect switch to wire harness.
5. Secure tray with four #8 Phillips head screws.
6.
Torque to 23–27 in•lbs.
Parking light socket
CAUTION: Discard ALL used fasteners and replace with
new. If using a fastener that does NOT have preapplied
thread lock, apply a medium-grade liquid thread lock.
Light switches
Screw location on tray
Switch and actuator