3
UAS P-Series Software Upgrade 574-848-2200
Procedure
1. Read and understand all instructions before starting work.
2. Stop the vehicle and turn off the engine.
3. Remove cover from cab overhead panel.
4.
Verify the LED indicator for the UAS module has a green “heartbeat” flash and a FOB is paired
to the module.
5. Unplug the black 8-way connector from module to disconnect power from unit.
Module 8-way harness connector
6. Remove cover from the module to expose the USB programming port.
7.
Insert the USB flash drive into the UAS programming port.
UAS module with flash drive in programming port
FLASH DRIVE
LED LIGHT
PROGRAMMING
SWITCH
8. Connect 8-way module power connector to harness.
9.
USB flash drive light will blink several of times. The module LED light will flash several times,
then enter heartbeat LED mode within (10) seconds.
10.
Remove thumb drive and replace sticky cover. The module will continue to flash after removing
the USB flash drive.
