UTC UDI-14, User Manual

Page: 55 / 58

55
PC Simulator
The PC Simulator function is used to perform a dive simulation without connecting the UDI- 14™ to the
computer.
The PC Simulator Dive depth graph shows the dive profile over time. In a dive simulation, the dive-
depth profile updates twenty times faster than real-time.
The
Tissue saturation graph updates as a function of the dive depth profile and is calculated at the
speed of the dive simulation.
The Dive configuration panel is used to adjust the dive parameters on the simulator as they are also
defined in the RGBM dive computer.
It contains the following:
Conservatism level – select from one of the 5 available levels (see
RGBM Model
on page
19
)
Altitude – select an altitude level for your dive location (see
Altitude
on page
19
)
EAN – define Nitrox percentage (see
Nitrox
on page
19
)
Max depth – insert maximum depth as if you are using in a dive plan, to determine the PO
2
limit.
Salt water – check if this is a salt water dive simulation
Deep stops enabled – check to allow this option.
The
Dive computer display panel shows the dive computer data as it appears in the UDI- 14™ dive
computer display during a real dive (see
Using the
on page 26).
The top of the Dive computer display contains the Up and Down buttons that serve a similar function to
the Up and Down buttons on the UDI-
14™ unit.
Click the Up button to see the RGBM setup parameters.
Click the Down button to see the last diver parameters.
The left side of the Dive computer display contains the simulator controls which are used to simulate a
dive:
Up arrow – moves the diver up
Down arrow – moves the diver down
Forward arrow – maintains the diver at the selected depth
Pause button – pauses the simulation. When paused, the button is red.