USTER HVI SPECTRUM, Instruction Manual, Page: 81 / 230

USTER
® HVI SPECTRUM
Instruction Manual
Uster Technologies, Inc. Chapter 6
Configurations • Page 6-5
2.1.1 Lot Limits
The
Lot Limits drop down box found on the T
EST
S
ETUP
Tab
(Refer to
Figure 6-2)
is used to establish a range of legitimate property values to
be used during System Testing. The customer can define these ranges,
as they will depend on the individual mill’s requirements.
When a sample property is measured during system testing and it falls
outside the valid Lot Limit, the system will produce a warning message.
This will alert the operator that a sample is outside the defined ranges
and is therefore not accepted by the database.
Note:
Lot limits are
not used
during module testing.
The software is shipped with one set of Lot Limits named
Default and a
selection for None . The operator can establish multiple sets of lot limits
for use with different cottons during system testing. As additional lot
limits specifications are defined and named, they will be displayed in
the lot limits drop down box.
Note:
The HVI SPECTRUM software allows up to twenty-two (22) sets
of lot limits to be saved.
To use a previously defined Lot Limit:
1.
Select the lot limit name by using the arrow keys to highlight your
selection from the
Lot Limits drop down box.
2.
Select the A
PPLY
button.
3.
If no lot limits are to be used, choose N
ONE
from the Lot Limits
drop down box.