USTER HVI SPECTRUM, Instruction Manual, Page: 27 / 230

USTER
® HVI SPECTRUM
Instruction Manual
Uster Technologies, Inc. Chapter 2
Installation • Page 2-1
Chapter 2 Installation
1
General Requirements
HVI SPECTRUM
and
HVI SPECTRUM I
units are each shipped in two (2)
separate crates, and the
HVI SPECTRUM II
is shipped in three (3)
separate crates.
These crates contain the module cabinets, the peripherals, and some
internal parts of the system.
Upon the arrival of these crates:
•
Inspect each crate for loss or damage.
•
Immediately report any loss or damage to the carrier.
IMPORTANT: For warranty purposes, ALL crates must be opened
by a qualified Uster Technologies’ service technician. It is important
that you
DO NOT OPEN the crates or attempt to set up the system
by yourself. SUCH ACTION MAY VOID THE WARRANTY.
•
Once the system is received, an Uster Technologies’ service
technician will schedule a site visit in order to install the instrument
with your assistance.
The instrument should ONLY be
installed by a certified Uster Technologies’ service
technician.
Note:
A plumber (pipe fitter) and electrician will be required the day of
installation to assist with the final connections of the compressed air and
electrical power.
IMPORTANT: If the system is to be stored before being used,
inside storage is
required
in a location that is protected from excess
moisture, corrosive atmospheres, and chance of physical damage.
Conditioned storage is recommended, but is not required. If the
instrument has been exposed to a cold environment, condensation
may form on cold surfaces when the instrument is moved into a
warm area. In such situations, allow the instrument to warm and dry
thoroughly before proceeding with installation.