SF-2110 User Guide – Rev. A
position and time information relative to each
9
50 Ohm input impedance
9
3Vdc > Input Voltage, High < 6Vdc
9
0Vdc < Input Voltage, Low < 1.2Vdc
9
Minimum pulse width, 100nsec
9
Rising or Falling edge Synchronization
ared EV MKR po
a nine
h a
ic p
10L
tch interface unit may be
nec
unable to drive the input.
Detailed specifications of the Event
put
This pulse can be used for a
Mark applications where relative
999mS
photograph taken.
pecifications:
S
Connecting the sh
pin, cable fitted wit
P/N 94-310262-30
An *event la
T
rt requires
lug, NavCom
Positron
F.
essary if the input device pulse is
Input, cable wiring, and configuration
may be found in Appendix D of this
User Guide.
*1 PPS
A pulse is available from the SF-2110 at an out
rate of once per second.
variety of Time/
timing is required.
Specifications:
9
15ns relative accuracy
9
Better than 100ns absolute accuracy
9
50 Ohm, TTL level
9
Pulse width, default 100mS, range 10 –
9
Pulse delay, default 0mS, range 0 – 999mS
9
Rising or Falling Edge Synchronization
2-36
* Consult Release Notes on the NavCom web site for availability.
Summary of Contents for SF-2110
