Installation
11/20
Fl Remote Set
10
Disconnect the 24V power supply cable (from the power supply
unit) from Fl and connect it to the DC input cable (8)
of the receiver (1).
Connect the DC output cable (9) of the receiver to the
Fl power supply connector.
This cable (9) is somewhat short, if necessary use the
DC extension cable (7).
5.4
Commissioning
Open the three wireless water sensors (2) by carefully (without
tools) levering the covers (bottom side, with the four golden
contacts) away from the upper part with your fingers.
Do not pull on the two internal sensor cables!
Danger of destruction!
Now insert the supplied 12V batteries (4). Please pay attention
to the po/-)!
Only 27A 12V special batteries may be used!
Carefully close the covers again.
