21
www.uscutter.com
425.481.3555
Loading the Material
• Always insert the material to be cut into the unit from the rear.
• Pull the vinyl up to the cutting bar in order to correctly set the zero point.
• If you use a roll of vinyl instead of vinyl sheets, the vinyl can be rolled off cleanly with the
aid of the roll holder supplied.
• When inserting the material, please ensure that the vinyl/material is inserted straight so that
tearing of the vinyl/material is prevented. The scaling guides at the front and back will help
to ensure this.
If the vinyl/material is inserted only a fraction of an inch short of straight this
could result in serious alignment problems later on.
• You can slide the material to any position in the unit, provided that the pressure rollers are
within the white/black squares on the crossbar.
• Lock the two pressure rollers by turning down the pinch roller lever on the outer edges of the
material (about 1/2 inch indented), so that the material is positioned and a maximum cutting
area is guaranteed.
• The pinch rollers can be adjusted by tensioning the spring to the desired pressure.
