5
BACKER PAD/DUST SKIRT INSTALLATION
1.
Use ¾” open end wrench to hold lower shaft and turn backer pad
clockwise to install.
2.
HAND TIGHTEN ONLY!
3.
Set machine upright on floor.
4.
Attach the removable part of the dust skirt (US115-146) to the
lower part of the deck plate so that the skirt just touches the floor.
(if not properly installed the vacuum system may not operate to its
full potential).
INSTRUCTIONS
WARNING:
1.
Make sure the Sander switch is in the OFF position before you
plug the unit in.
2.
Never change the sandpaper while the sander is plugged in.
3.
Check breaker circuit to be used, 20 amp is the minimum
required.
4.
Always wear eye protection, ear protection and dust mask while
operating the sander.
5.
Empty the vacuum system in an area away from flammable
materials and flame or fire.
TOOLS NEEDED
1.
Hammer
2.
Pry bar; to remove trim
3.
Paint scraper; to scrape corners and hard to reach places.
4.
Nail set
5.
Vacuum system; using a 1.5” ID vacuum hose to collect dust
created by sanding process.
6.
Plastic draping; to cover and isolate work areas.
7.
Masking tape
8.
Wood filler
9.
Mineral spirits and or tack cloths; to remove fine dust particle
prior to coating floor with finish.