Wireless USB Print Server User Guide
Wireless USB Print Server User
Guide
Installation
Wireless USB Print Server Installation
Unix Installation
Unix
Overview
Your Wireless USB Print Server supports the LPD Unix printing method, which is
supported by all common Unix systems.
You must configure both the Wireless USB Print Server and your Unix system, as
described in the following sections.
Wireless USB Print Server IP Address Configuration
Because it supports dynamic IP Address allocation using DHCP or BOOTP, the Wireless
USB Print Server ships with an IP Address of 0.0.0.0. This is NOT a valid IP Address.
Therefore, you must do ONE of the following:
●
Check your
DHCP server
(if you have one), and determine the IP Address
allocated to the Wireless USB Print Server.
●
Configure your
BOOTP Server
(if you have one), to provide an IP address to
the Wireless USB Print Server, then restart the Wireless USB Print Server.
●
Use a Windows platform and run the
Setup Wizard
or
BiAdmin
utility to
allocate a valid IP Address to the Wireless USB Print Server.
●
Add an entry to the
arp
table to associate the hardware address of the Wireless
USB Print Server with the desired IP address, as follows:
file:///G|/CSO/T-Writer Repository/Networking/5436A Wireless Gutenberg/User Guide/English/install_unix.htm (1 of 8)9/14/2006 4:36:16 PM
