US Digital E6, Assembly Instructions

Page: 1 / 2

E6 Differential Assembly Instructions
support@usdigital.com ▪ www.usdigital.com
Local: 360.260.2468
▪
Sales: 800.736.0194
Support: 360.397.9999
▪
Fax: 360.260.2469
1400 NE 136 th Ave.
▪
Vancouver, Washington
▪
98684
▪
USA
1.0
Page 1
Please Note: These instructions apply to the E6 differential version
only .
Step 1:
Base Mounting
Place encoder base onto mounting surface. Slip the
centering tool over shaft and into center hole of
base. Hold pressure on centering tool to align base
and tighten mounting screws. Remove centering
tool.
Transfer Adhesive: Peel off paper backing, place
centering tool into center hole of base, slip
centering tool onto shaft and slide base and
centering tool down onto mounting surface as one
piece. Press to form a good bond, then slip
centering tool off shaft and continue with standard
mounting instructions.
Step 2:
Hubdisk and Spacer Alignment
Lay spacer tool flat on the base so that it straddles
the shaft. Orient hubdisk so that the set screw is
between the disk and encoder base. Slip hubdisk
assembly onto shaft and slide down until it bottoms
out against spacer tool.
Step 3:
Hubdisk Installation
Tighten set screw with hex wrench provided while
pressing down on hub to ensure contact with
spacer tool. Remove hex wrench and spacer tool.
Hub Set Screw:
2-3 in-lbs torque