E5 Single-Ended Assembly Instructions
▪
www.usdigital.com
Local: 360.260.2468
▪
Sales: 800.736.0194
Support: 360.397.9999
▪
Fax: 360.260.2469
1400 NE 136
th
Ave.
▪
Vancouver, Washington
▪
98684
▪
USA
8.0
Page 1
Please Note:
These instructions apply to the E5 single-ended version
only
.
Step 1:
Secure base to mounting surface using two or three
screws. Slip the centering tool over shaft and into
center hole of base. Tighten mounting screws.
Remove centering tool.
Transfer Adhesive:
Contact US Digital technical
support for mounting assistance.
Step 2:
Place spacer tool around shaft.
Slip hub disk assembly onto
shaft with codewheel disk
towards top until it bottoms out
against spacer tool.
Note: Alternate spacer
orientations may be required
depending on base/mounting
configuration.
Step 3:
Tighten set screw with hex
wrench provided while pressing
down on hub.
Alternate spacer tool orientation
for G-Option base
Hub Set Screw:
2 – 3 in-lbs torque
