Ursalink UG65 Quick Start Guide
www.ursalink.com
7
3. Hardware Installation
3.1 SIM Card Installation
UG65 does not support hot plugging (also called hot swapping). please turn off the power before you
insert or take off cards.
A. Use screwdriver to open the protective cover on the back panel of UG65.
B. Insert the SIM card into the device according to the direction icon on the device.
Note:
If you need to take out the SIM card, press into the SIM card and it will pop up automatically.
3.2 Ethernet Cable & Power Cable Installation
A. Connect the Ethernet cable and power cable to corresponding interfaces.
B. Pass two cables through the waterproof silicone and slid into the grooves.
C. Screw the protective cover back to the device.
UG65 also supports 802.3af standard PoE and can be powered by PoE switch or PoE adapter. When
connecting, Ethernet cable of UG65 device side should be installed first, otherwise, PoE devices or gateway
may be damaged.
3.3 Antenna Installation
For external antenna version, rotate the antenna into the antenna connector accordingly.
The external antenna should be installed vertically always on a site with a good signal.