EM500-CO
2
User Guide
17
6.
Installation
EM500-CO
2
should be considered following notes to insure proper installation:
CO
2
sensor should be mounted no higher than 12-18 inches above the floor since CO
2
is
heavier than normal air and will flow down.
Installation should be considered the layout of a space. Enclosed spaces or varying spaces
are recommended to install one more sensor.
6.1 Wall Mounting
1. Attach the mounting bracket to the wall and mark the two holes(around 16mm) on the wall.
Note:
The connecting line of two holes must be a horizontal line.
2. Drill the holes according to the marks and screw the mounting screws into the wall.
3. Mount the device on the wall.
6.2 Pole Mounting
1.Loosen the hose clamp by turning the locking mechanism counter-clockwise.
2. Straighten out the hose clamp and slide it through the rectangular holes in the mounting
bracket, wrap the hose clamp around the pole.
3. Use a screwdriver to tighten the locking mechanism by turning it clockwise.
Summary of Contents for EM500-CO2
Page 1: ......
