55
DS1168-013C
• When the device is set up as a WiFi access point, the following screen appears on the display:
Controls
and
have the following functions:
•
exit the advanced c
onfiguration of the display module and restart the device.
•
Clear the user directory and reset all the display parameters to default setting.
• Press control
to open the following page,
where the control
returns to the previous screen, while the one with the icon
resets the device and
then restarts.
3) Numeric keypad module (Ref. 1168/46)
• Switch off the device.
ATTENTION:
Remove the power supply from LINE terminal of the door unit and not from RS485 BUS cable of the
device.
•
Hold the reset button (PROGRAM) (31) pressed.
•
Power the device while holding the button pressed. A long beep will be heard.
•
Release the button after 5 seconds.
The device will beep three times for confirmation when the button is released.
All the previously programmed codes, times and passwords will be deleted.
4) Proximity key reader module (Ref. 1168/45)
• Switch off the device.
ATTENTION:
Remove the power supply from LINE terminal of the door unit and not from RS485 BUS cable of the
device.
• Press the configuration button (43) and, holding it pressed, power the device again.
• Hold the button down until the following caption is cleared:
• At this point, the display will start a count-down, clearing the user key memory.
• Release the key.
• Wait for the end of the count and return to normal functioning.
6 MAINTENANCE
It is suggested to clean the front of the modules with a damp, non-abrasive cloth. Do not use products containing
alcohol or window cleaning products.
