52
DS1168-013C
Repeat the same operations for all the keys to be deleted or replaced.
To return to normal functioning, place a MASTER key close to the front panel.
SETTING OF RELEASE OPEN TIME
When you access this menu, the display indicates the currently set door release time (factory setting: ‘t00’).
The door release time can be set between 0 and 99 seconds.
Move the MASTER key close to the panel and hold it in position for at least 2 seconds. The LED display shows:
The display increases the first bar by one unit at a time every second in a cyclic way (from 0 to 9).
Remove the MASTER key when the digit to be set is displayed.
Approach and remove the MASTER key so as to also set the second digit. At this point, the display will show:
‘tXY’
where ‘XY’ is the new door release time set.
Approach the MASTER key again to make the changes effective (“Sto” appears on the display to indicate that it
has been stored).
4.2.2 ADVANCED PROGRAMMING FUNCTIONS
A number of particular functions, not generally used, are described below.
DELETION OF AVAILABLE KEYS
To delete an available user key from the memory, you can use a simpler procedure than that described above for
lost keys:
WARNING: the procedure must be performed with one key at a time.
• using a MASTER key, access the deletion menu with the following shown on the display:
•
present the key to be deleted.
• if the key presented is effectively present in the memory, the buzzer will emit three beeps and the display will
show the ‘key number’ for approx. 7 seconds.
• when the key number is shown on the display, present the MASTER key to confirm deletion.
To restore normal functioning, present a MASTER key to the front panel.
4.2.3 ACCESS IN THE CASE OF LOSS OF MASTER KEY/STORAGE OF NEW MASTER KEYS
It is always possible to access a device, even without the MASTER keys, provided you have a blank key, i.e. a key
that has never been stored as user key on that device.
Proceed as follows:
•
open the frame, so as to access the rear button.
•
press the rear button
briefly
;
• wait until the following is displayed:
• press the rear button again briefly
;
•
present the blank key which will be stored as MASTER key in addition to or in replacement of (if 3 have already
been stored) of the MASTER keys present.
• present this new MASTER key for at least 7 seconds so as to restore normal functioning.
•
use this new MASTER key to access the device.
