2.3.1.7 Enable
rec
This option is used to enable or disenable selected camera recording. To enable, select the respective check box using “
◄►
”
and press “
ENTER
” or “
EDIT
”.
Symbol “ ” indicates that the recording option is enabled; symbol “
×
” indicates that it is not.
2.3.1.8 Schedule
Select “
Schedule
” and press “
ENTER
” to access the programming menu shown below.
Figure 27: recording programming menu
The selected item is highlighted.
Press arrows “
◄►▲▼
” to p
Point the cursor to the requ
oint the cursor to the various menu items.
it it. Use buttons “
▲▼
” to change the available options for the
indow closes to quit the configuration menu.
e
IMPO
•
will resume recording only recording tasks programmed in the “
Registrazione
” menu after a
Recordings started manually will not be resumed after a blackout.
2.3.1.8
This opt
g on the selected camera for day of the week.
Use “
▲
This op
to set up to 4 recording periods for each day of the week with respective event start and end times. The
recording mod
for each period.
2.3.1.8.2 A
d day.
►
” and press “
ENTER
” or “
EDIT
”.
t the whole day recording option is enabled; symbol “
×
” indicates that it is not.
mot det
alarm
mot / alm
mot & alm
command
All time
In this mode, recording is continuous for 24 hours.
e
IMPORTANT NOTE
If “
All Time
” is selected, in the event of a blackout or if the device is switched off, the device will automatically resume recording
as soon as network voltage is resumed and the device is switched on again.
Motion
In this mode, recording starts as soon as motion is detected.
ired item and press “
ENTER
” to ed
selected menu item.
Select “
CONFIRM
” and press “
ENTER
” to make the changes effective.
Select “
CAN
nd press “
ENTER
” to cancel the chan
Press “
ESC
” to go back by one step.
CEL
” a
ges.
Press “
ESC
” several times until the configuration w
RTANT NOTE
The device
blackout.
.1 Day
ion is used to set and program recordin
▼
” to select.
tion can be used
e can be defined
ll
day
You can also enable recording for the entire selecte
To enable, select the respective check box using “
◄
Symbol “ ” indicates tha
Check the “
All day
” option to define the recording mode.
The following recording modes can be selected:
all time
DS1093-022
40
