1 GENERAL
SETTINGS
Dear Customer,
Thank you for having purchased this Urmet product.
This document is a simple, quick reference guide to help you access the main functions of the URMET Domus S.p.A. Digital
Video Recorder Ref. 1093/061S.
For more detailed information about the devices, refer to the full instruction manual inside the CD provided with the product.
1.1 SWITCH-ON
Plug the power connector into the specific socket on the back of the unit and switch
on the back of the unit to position 1.
The green power warning light on the front panel will light up. The welcome page will appear on the monitor.
Figure 20: welcome page
The device initialisation processes will appear at this point.
hard disk is either not installed or not found. The alarm option can be deactivated
in the “
Exce
1.2
e
IMPORTANT NOTE
The device will output an acoustic signal if the
ptions
” menu.
SWITCH-OFF
The device can be switched off in two ways.
direct switch-off
switch-off from main menu
rogress before switching the unit off to prevent damage to the hard disk.
Press the power button on the back..
ES
” and press “
ENTER
”. Select “
POWER OFF: START
” and press
“
ENTER
” to confirm.
1.3
Make sure that no recording or playback is in p
1.2.1 DIRECT
SWITCH-OFF
1.2.2
SWITCH-OFF FROM MAIN MENU
Press “
MENU
” to access the main menu. Select “
UTILITI
“
ENTER
”. Press again
REMOTE CONTROL ENABLE
The rem
Enabli
ote control must be enabled to control the device.
ng procedure
Press “
DEV
” on the remote control.
e
IMPORT
NOTE
ntrol all
•
r deactivating the remote control: the green “
STATUS
” LED on the DVR will go
•
You will need to repeat the remote control “enabling/addressing” operation whenever the device is rebooted.
1.4
MESSAGES ON THE MONITOR
Enter the default address for controlling the DVR using the remote control: press “
01
” on the remote control.
Press “
ENTER
” on the remote control.
ANT
•
Define a different address for each device if several DVRs are installed, otherwise the remote control will co
DVRs with the same address at the same time.
Press “
DEV
” on the remote control fo
out.
The edges of the picture may not be completely visible on some “CRT” monitor models.
DS1093-022
31
