DS1067-063D
98
LBT20064
6.2
ACQUISITIONS OF BUS DEVICES
6.2.1
Position of the programming buttons
For the acquisition of the bus devices, use their programming buttons (PROG).
The images below demonstrate where these buttons are positioned.
Figure 63 - Position of the programming buttons
To acquire a 1067/026 touch screen keypad, it is sufficient to press the
T4
key when the following message appears on
the display.
Figure 64 - Message of 1067/026 keypad acquisition
6.2.2
Procedure for acquiring bus devices
IMPORTANT!
The instructions below assume that the devices have not yet been acquired.
Otherwise, see Chapter 7 -
To acquire the various devices on the system bus, follow the instructions below:
1. Select the keypad to be used to acquire system devices from among the keypads present in the system. It is
also possible to use the service keypad (see paragraph
7.11
).
2. Press the programming button (PROG) on the keypad display (if there is a 1067/026 keypad, press
T4
. The control
panel registers it by assigning the
“TS01” address. If it is a service keypad, it will be assigned the address “TS08”.
3. The «MAINTENANCE» / «LINGUA-LANGUAGE» menu will appear on the keypad display. If the language is to be
changed, press the
OK
button, otherwise press the ▼ key until «MAINTENANCE» / «ACQUIRE» appears, press
OK
again and go on to point 7.
4. «LINGUA-LANGUAGE» / «TS01:TS 01» appears on the display (second line). TS01 is the first keypad of the
system, or the one that was just acquired. If the service keypad is being used, the message «TS08:TS 08». will
appear. Press the
OK
button.
5. «ITALIANO» will appear on the display.
Use the ▼▲ keys to select the language desired and confirm the selection
by pressing the
OK
key.
6. «Download in progress >>>>...» will appear on the display. When the download of the new language is complete,
the message «DOWNLOAD OK» will appear. Press
OK
and then
ESC
.
IMPORTANT!
During the download, the power supply must absolutely not be disconnected from the keypad!
7.
“ACQUISITION IN PROGRESS...” will appear on the display and the control panel is ready to acquire other devices.
8. Proceed with the acquisition of the other devices by pressing the programming button of each of them.
The yellow LED located next to the button of the device will turn off as soon as it is acquired.
Each time a new device is acquired, the keypad emits 3 beeps and the device type will appear on the display (TS=
keypad; ER= expansion; LT= reader; EW= radio expansion; AS= POWER/S.) with the address assigned to it.
Once the acquisition of all the devices is complete, press
ESC
to exit from the menu.
Now it is possible to proceed with the system configuration as illustrated in the Programming Manual.
IMPORTANT!
The addresses are assigned progressively and according to family of belonging; it is not necessary
to follow a pre-established order. If the operator wants the device addresses to follow certain logic, they must be
acquired in that order.
1067/092 EXPANSION
KEYPAD
EXPANSION
READER
RADIO EXPANSION
Summary of Contents for 1067/024
Page 118: ...DS1067 063D 118 LBT20064...
Page 119: ...DS1067 063D 119 LBT20064...
